Tavor X95 Thin Buttplate

A thin buttplate for your Tavor X95.

NFA Warning:

Please note that if you attach the Tavor X95 thin buttplate to a 16.5″ barreled rifle, it will change your rifle to a short barreled rifle (SBR) subject to all the requirements of the National Firearms Act (NFA) for SBR’s.

If you attach the thin buttplate to an 18.5″ barreled rifle, you will have a gun that is over the 26″ minimum OAL requirements and will not be subject to the NFA.

ALL NFA RULES APPLY. It is your responsibility to remain in compliance with the NFA!

It is your responsibility to ensure you follow all local, state and federal laws in regards to installation and use of the Tavor® X95™ thin buttplate.

Made of polymer
Made in Israel

If you have the Tavor X95 ​manual Rev 00 please follow Section 14.1.3 then you will then use two flathead screwdrivers to remove the existing buttpad.
If you have the Tavor X95 ​manual Rev C or D please follow Section 14.1.4 then you will then use two flathead screwdrivers to remove the existing buttpad.